Starting the aquarium
Everyone who has decided to acquire such a miracle of the underwater world, like an aquarium, experiences many difficulties. All because many even have no idea what it takes to make a beautiful large aquarium glad eye, and was not just a source of problems.
Where to begin?
First you need to determine the volume. Here the following principle operates: the more it is, the easier it is to take care of it. This is because in a large aquarium it is much easier to establish and maintain a biological balance, which is a pledge of a clean aquarium. So, if you give more food to pets than they eat, the rest of it will start to decompose, and the water will quickly become cloudy.
Running the aquarium (the step-by-step instruction of this process will be described below) is a rather complicated manipulation, and before starting it, determine the location of it. In this case, you must avoid getting direct rays of the sun on it. It is also forbidden to install the aquarium in a draft or on a windowsill. The most appropriate option is to place it in a corner far from your window, which will ensure a quick start of the aquarium, the step-by-step instruction of which describes this feature.
An important factor is the curbstone. Now there is a huge range of these interior items, designed specifically for the aquarium. It can be made to order and even independently, correctly calculating the strength of the structure. The height of the pedestal together with the aquarium should not exceed 120-130 cm, otherwise the maintenance of the aquarium, or rather its cleaning, can cause certain difficulties associated with access to it.
Any correct start of the aquarium requires a preconceived sequence of actions. Having determined the volume, location, stand, you need to think about the necessary equipment for your artificial ecosystem. In this case, everything depends on the capabilities of the breeder, since there are a huge number of models on the market at different prices, from different manufacturers. Recall only that the integral attributes of any aquarium are the filter, pump, heater. This is the very minimum, without which the existence of fish is impossible.
Starting the aquarium
Preparing the aquarium for start-up is a rather complicated process that needs to be paid special attention before putting it into the installation site. Before pouring water into it, wash all the glass cleanly inside and out. For this, you can use a solution of baking soda, as well as a slightly pink solution of potassium permanganate.
Now you can start running the aquarium. The step-by-step instruction of this process has many points and can be changed in each specific case. Therefore, we consider only some of the main points.
1. Having installed the washed aquarium on the cabinet, once again inspect it for the absence of cracks and deep scratches.
2. At the bottom lay washed and calcined primer.
3. Plant plants and strengthen them.
4. Then gradually, in a small stream, pour water over the wall of the aquarium.
So the aquarium should stand for a week. Only after this, you can run fish. As you can see, after reading this article, launching an aquarium, the step-by-step instruction of which is described above, is not such a complicated process as it seems at first glance.