How to fill the lighter with gas correctly
Gas lighters are a very convenient and popular tool. They are used by a huge number of people. But one day a moment comes when the fuel inside the hull ends. At the same time, many people have a question about how to fill the lighter with gas. This is a simple matter. However, everything must be done carefully and carefully. So, consider this process step by step.
How to properly fill the lighter with gas is an important question. But it is equally important to know what kind of fuel you need to use. In order for the tool to work smoothly, and its components are not clogged, the refueling must be carried out only with butane gas of triple purification. Before this, it is necessary to release the lighter from the remaining air in it. Of course, the gas itself must also be used completely. From the air that always remains in the hull after the fuel is exhausted, dispose of as follows. The regulator of gas supply is put on "minimum". The flue level valve in most lighters is located in the base area and it will not be difficult to find it.
The answer to the question of how to fill a cigarette lighter with gas is completely not complicated. You just need to show a little sleight of hand. In order to release air, then simply take a needle, a thin pin or any other similar sharp tool and push the suction valve off. After that, all the extra will come out of the lighter. Then, to fully guarantee the result, you need to click the lighter. Of course, you will not see the fire, but if the air or remains of butane are still in the hull, they will come out completely.
Now let's look at how to fill a lighter with gas, using a can. To do this, it is tightly clamped in the hand and turned over. Further into the valve located below, insert the tip of the container with the gas and press strongly. Keep the cans in this way you need 5-10 seconds. Then it is sharply pulled from the lighter. Be sure to hold the can only with the nipple down. In the event that everything is done correctly, you will not feel a characteristic chill, since the gas will not come out, but will go straight into the case of the lighter.
During the refueling, you will hear a characteristic hissing sound. Some cans are equipped with special dispensers. In this case, you have to refuel in several receptions. The filling of the body with gas refers to adiabatic processes, which are always accompanied by a certain decrease in temperature. Therefore, before you start using a cigarette lighter, you should wait a little while it warms up. A lot of time it will not take more than five minutes.
Sometimes the owners of expensive imported lighters, not risking to conduct such an event on their own, are interested in where to fill the lighter with gas for money. This is usually done by specialized workshops. Residents of small towns, most likely still have to take a balloon and refuel the lighter on their own. Living in the megacities suitable workshop will not be difficult to find. For example, Muscovites owning DuPont lighters have the opportunity to take them to the last floor of the TSUM, to the official representative office of Dupont.
So, now you understand how to fill the lighter with gas. With skillful hands, it will not be difficult.